PING innovations Facewrap and Spinsistency combine to deliver greater distance and spin predictability so your approach shots reach greens and hold greens. A tungsten back weight on the extreme perimeter helps increase MOI for more stability and forgiveness. Available in 2H thru 7H.
Spinsistencyâ„¢
A complex face curvature modifies the roll profile, mainly low on the face where loft decreases, to bring more consistent spin performance and increase ball speed for added distance.
Facewrapâ„¢
The thin, high-strength maraging steel face wraps into the crown and sole to increase flexing for faster speeds that result in greater distance and high-launching shots.
Alignment Guide
On the crown, a new 3-dot alignment feature (large dot in the middle) offers alignment guidance and inspires confidence at address.
Tungsten Weighting
A tungsten sole weight strategically positioned in each club increases the MOI in the stainless steel head for added forgiveness.
Easy Adjustability
Trajectory Tuning 2.0 utilizes a lightweight, aerodynamic hosel sleeve that provides eight positions to customize your trajectory for maximum distance and accuracy.
Trajectory Tuning Chart
Trajectory Tuning 2.0 in the G410 utilizes a lightweight, aerodynamic hosel sleeve that provides eight positions for influencing ball flight through loft (±1.5°) and lie adjustments, including up to 3° flatter than standard.
Stock Shaft
The PING Alta CB Slate is stock, our proprietary, lightweight shaft custom-engineered to deliver high launch with stability and a consistent feel.
CLUB |
LOFT |
LENGTH |
LIE ANGLE |
2-Hybrid |
17.0° |
40-3/4" |
57.0° |
3-Hybrid |
19.0° |
40-1/4" |
57.5° |
4-Hybrid |
22.0° |
39-3/4" |
58.0° |
5-Hybrid |
26.0° |
39-1/4" |
58.5° |
6-Hybrid |
30.0° |
38-3/4" |
59.0° |
7-Hybrid |
34.0° |
38-1/4" |
59.5° |
Notes
- Lie angle is an average of the five adjustable loft positions indicated on the hosel.
- Swingweights with Aldila Rogue and Mitsubishi Tensei shafts are 1 point higher than standard.
- Swingweights with Alta Slate R and SR shafts are 1 point lower than standard.
- These are design specifications that may vary due to manufacturing tolerances.
- Available in left- and right-handed models.